Qume DataTrak 8 Instrukcja Obsługi Pobierz pdf (Strona 7)

SHUGART SAS50/S51

------- ---------

START WITH THE DISK DRIVE(S) SET TO FACTORY CONFIGURATION AS

DESCRIBED IN THE SER1VE AND MAINTENANCE MANUAL. THEN PERFORM THE

FOLLOWING ALTERATIONS TO THE DRIVE(S).

1. REMOVE THE ‘IW’ PLUG. THIS ALLOWS FOR LOWER WRITE CURRENT ON

THE INSIDE TRACKS.

2. REMOVE THE ‘RS’ PLUG AND INSTALL THIS PLUG AT ‘RM’. THIS

ALLOWS DRIVE READY TRUE WHEN DIRECTION (SIDE SELECT) IS

SELECTING THE WRONG SIDE OF A SINGLE SIDED DISKETTE.

3. BREAK CONNECTION ‘X’ ON THE SHORTING PLUG AND INSTALL A PLUG

AT ‘C’. THIS ALLOWS THE DRIVE TO BE SELECTED WITHOUT ENABLING

THE STEPPER OR LOADING THE R/W HEAD.

4. BREAK CONNECTION ‘l’ ON THE SHORTING PLUG AND INSTALL A PLUG

AT ‘Y’. ACTIVITY LIGHT ON FROM R/W HEAD LOADED.

5. REMOVE THE ‘S2’ PLUG AND INSTALL AT ‘S1’. THIS ALLOWS SIDE

SELECT FROM THE ‘STEP DIRECTION’ SIGNAL.

6. REMOVE THE ‘851’ PLUG AND INSTALL AT ‘850’. THIS IS FOR SOFT

SECTORED DISKETTES.

7. INSTALL A PLUG AT ‘2S’. THIS ALLOWS THE DRIVE TO ISSUE THE

‘TWO SIDED’ SIGNAL WHEN TWO SIDED DISKETTES ARE INSERTED.

8. REMOVE THE ‘DL’ PLUG.

9. SET -5/-15 ACCORDING TO THE NEGITIVE SUPPLY VOLTAGE YOU ARE

USING.

10. DRIVE A: INSTALL PLUG AT ‘DS1’.

DRIVE B: INSTALL PLUG AT ‘DS2’.

DRIVE C: INSTALL PLUG AT ‘DS3’.

DRIVE D: INSTALL PLUG AT ‘DS4’.

11. REMOVE THE TERMINATOR FROM ALL BUT THE LAST DRIVE ON THE

RIBBON CABLE.

12. INSTALL JADE DOUBLE D ECN # 5.

----------------------------------------------------------------

ENGINEERING

1 2 3 4 5 6 7 8 9 10 11 12 ... 46 47

Brak uwag

Qume DataTrak 8 Instrukcja Obsługi Strona 7